this is obsolete doc -- see http://doc.nethence.com/ instead

Using the Management Processor on HP Integrity (Itanium64) systems 

BP : Reset BMC Passwords PC : Remote Power Control 

CA : Configure asynch/serial ports PM : Remote Power Mode Control 

DATE: Display Date PR : Power Restore Policy Config. 

DC : Default Configuration PS : Power management module Status 

DF : Display FRU Information RB : Reset BMC 

DI : DIsconnect users RS : Reset System through RST signal 

DNS : Configure DHCP and DNS SA : Set MP Access 

FW : Upgrade MP firmware SNMP: Configure SNMP parameters 

HE : Display Help SO : Security Options 

ID : System Information SS : System processors Status 

IT : Modify MP inactivity timeouts SYSREV: Display System firmware Revs. 

LC : Configure LAN, SSH and Web ports TC : Reset system via INIT 

LDAP: Configure Directory parameters TE : TEll- send a msg. to other users 

LM : License Management UC : User Configuration 

LOC : Locator LED display WHO : Display connected MP users 

LS : LAN Status XD : Diagnostics and reset of MP 

Introduction 

Make sure SSH is enabled from the ILO interface, 

https://ILO_ADDRESS/

Note. eventually disable telnet. 

Get to the Management Processor 

^B

Note. also "ESC-B" 

Configuration 

Clear all event logs, 

^B

sl -c

Note. or "sl -clear" 

Configure MP LAN, 

^B

cm

ls

lc

then, 

d (disable dhcp)

i (define IP)

s (define netmask)

g (define gateway)

note. to apply, proceed with a complete hardware reset, not just an MP reset 

Usage 

View main menu available commands, 

^B

he

li

View command menu available commands, 

^B

cm

he

li

Power management, 

^B

cm

pc

on

and get to the console, 

^B

co

Quit, 

^B

x